About the Assembly category
Assembly Q's (heatbed and servo)
MKS Gen 1.4 ok to use?
PICA Arduino Due compatibility
Pica Rev E wiring SSR
Questions on A Mostly Wilson TS to Wilson 2 with the kit
Pica PS_ON pins?
400mm cubed print area Wilson 2
3 wire endstops on PICA
Missing Parts ... maybe?
Is Y endstop min or max?
It's Alive! It's Alllliiivvee!
Test fitting my Wilson 2 frame
Confusion over extruder fans
Z and X Rods conversion
What's the difference Z-Lower-Brace and power supply
Need help completing the build - 4 issues
Printing Wilson II parts Questions
BoM Bearing, Nuts and Bolts, using different length and removing some of it?
Heated Bed - Which side up?
PICA rev c Wiring questions
Cable Chain (drag chain)
Loose smooth rods in the z-axis part of the design?
2 little problems :)
12V heatbed not heating up after assembly
RAMPS jumper settings
Excact dimensions of the wilson bed 20*30
Wiring the Wilson2 Heat Bed
24v version PICA Control Boards
next page →