About the Mods category
IR Z-Probe on hot end
10mm Lead Screws for Wilson II?
Made a new printhead from scratch
Titan extruder setup
Wilson II K - Stiffer Y axis & Wire management
Size of extrusion and rods needed for a 300mmx300mmx200mm build
Mega Wilson - Y axis upgrade
The laser cut MDF Y carrage and possible replacements
Ikea Wilson II Enclosure
Need diagnostic help - Hot End not heating
E3D V6 Extruder Upgrade?
Dual Bowden Suggestions
Diet time! Weight reduction on the extruder - titan /w pancake stepper
Design: Fan Duct for Radial/Blower Style Fan
Preview: Anti z axis wobble for Wilson 2
Filament Width Sensor
Modular ATX Power to multiple Wilson IIs
Wilson II Plus 50
Linear bearings for y carriage on the Mega
Redesigning the y-bed?
Upgrading perhaps the oldest unfinished Wilson TS in existence
PEI bed - suggestions?
PEI: Giving It a Try
Raising the Z Bridge
Added lights to my Wilson II
PC Power Supply Brackets
Chasing some rigidity on the tower
next page →