About the Troubleshooting category
Banding? on layers with retraction
Trouble setting up auto-leveling in Marlin
Z-axis not working
Print Quality Issues
PID Autotuning Help
Extruder extruds 4 times more than G-code command
Z motor issue with brand new kit
Electronics fan is it necessary?
Cannot track down an under extrusion issue
Z-axis sled raised before Z probe [Solved]
First Print on my Wilson II
Motors stall on first powerup
Repairing PEI Blisters
Greetings folks... some help needed please
RepRap Discount Smart Controller display all squares
Lost initial x, y, z pos settings?
Heatbed melted connection on Ramps
Print Quality vs Prusa i3 mk2
Smart Full Graphic Not working on 12v
Z motors moving at different speeds
Help understanding auto bed leveling
Just updated Marlin to latest release (1.1.0-RC8) and display is no longer interactive`
Over Extrusion or Bad Layer Height?
Esteps very different from those seen here
Troubleshooting Y Solved!
What is going on with my Y axis?
Any idea what would cause this hole?
What is going on with my X axis?
next page →