Assembly Q's (heatbed and servo)


I’m finishing assembly of my Wilson II and have a couple questions.

  1. My board is different than the one in the assembly videos. Which connections does the heatbed use? It looks like D2 and D8 are open and have the correct size spades but the wires are not labeled.

  2. Video 7 talks about hooking up a servo and an axillary power supply. My kit came with no such servo or PS. Was that for a prior iteration of the design?


  1. If you have the new board you can find the information on how to wire it up here:


You might have trouble on mobile with that.

  1. Yes if you have the rack and pinon z-probe you don’t need this part of the video any longer.


Thanks. Everything is up and running and the first print came out great.