Max speed/acceleration


#1

Hi,

I have my 300300300 Wilson 2 running quite well, and am trying to speed it up. I did have my speeds between 20-50 with all accelerations at 800. When I try to go a lot faster I’m getting layer shifting which is probably from the motor drivers overloading.

Anyway, I’d be interested in hearing if anyone with a Wilson2 and RAMPs is reliably printing at higher accelerations/speeds and especially what speed/acceleration setting you are using…

Lee


#2

I print comfortably with an acceleration of 1000 and spreed up to 60mm/s on a 200x300x200, so quite similar to you.
I also have layer shifting when trying to go above these values.