Anyone running this setup? I want to upgrade but want to know if its been done
Bump anyone done this yet?
I don’t see why it wouldn’t work. Sounds like a great upgrade path.
Be prepared to modify the x carriage. On mine, I ended up just clipping off the z-pinion at the bottom. Gained some Z height back too.
I am not sure what difference between MKS Sbase and Ramps 1.4.
I run Titan and 3DTouch (which is the Geeetech ripoff of the bltouch and exactly the same) on Marlin firmware. if you want a copy of my firmware i can send it to you.
MKS Sbase is 32bit and runs on smoothieware
MKS Base is 8bit and runs on marlin 1.1RC8
So you’d have to create your own smoothieware config as the marlin one wouldn’t work.
Mind sharing your mount perhaps please?
My extruder bracket. Like some of my new design I am starting to use the 3m heat insert brass threads. Details are there to see.